Canon imageCLASS MF7470 Manual

3-27

You can set the Book Frame Erase mode only for the original 
paper sizes shown on the touch panel display.
To select an A or B series paper size, press [A/B-size].

To enter values in millimeters, press [mm].
When entering values in millimeters, you can also use 

–

 

(numeric keys), and 

 (Clear) to clear your entries.

You can change the values by pressing [-] or [+], even if you have 
entered the values using 

–

 (numeric keys).

If you enter a value outside the setting range, a message 
prompting you to enter an appropriate value appears on the 
screen.
The maximum book frame erase width that you can set is <1 
15/16" (50 mm)>.

Press [Center] and [Sides].
Press [-] or [+] to set their respective frame erase widths, then 
press [OK].

Press [Adjust Each Dim.].
Select the desired frame erase borders.
Press [-] or [+] to set their respective frame erase widths, then 
press [OK].

To return to the screen for setting the same width for all four borders, 
press [Adjust All At Once].

–

–

–
–

–

–

–

●

–
–

●

–
–
–

To cancel this setting, press [Special Features] → [Frame Erase] → 
[Cancel].
To cancel all settings and return the machine to the Standard 
mode, press   (Reset).

This mode erases the shadows that appear on copies from binding 
holes on originals.

The Binding Erase mode cannot be used with the Book 

▶ 2-Sided, Two-

page Separation, or Different Size Original mode.
Do not place originals with binding holes into the feeder, as this may 
damage the originals.
If you are using the Binding Erase mode, the borders you do not select 
are also slightly erased.

The border is where the binding holes are located on the original, if 
you visualize the original as being face up.

–

–

–

–

–