Canon VB-M720F Manual

Setting the Camera Angle

mera Ang

ting T

ool

(9) [Zoom] slider

The slider to operate the zoom ratio.

(10)[Zoom] button

The button to operate the zoom ratio.

(11)[Control Assist Display] selection box

Select whether to [Enable] or [Disable] operation

assist in the video display area.

(12)[Control Button Display] selection box

Select whether to [Enable] or [Disable] the [Pan]

button and [Tilt] button in the video display area.

(13)[Control Assist Correction]

If the control assist display does not match the actual

camera angle, click [Control Assist Correction] to

confirm the actual camera angle and automatically

correct the control assist display position.

Control assist correction takes approximately 1

minute.

(14)[Digital Zoom]

Set digital zoom to [Enable] or [Disable]. If you select

[Enable], the digital zoom boundary is displayed for

the zoom slider and the digital zoom operation

becomes possible.

The higher the digital zoom ratio, the lower the image

quality becomes.

(15)[Image Flip] selection box

Select the orientation of the camera image.

If [Enable] is selected, the image will be rotated 180

degrees.

(16)[Focus]

You can control the focus.

(17)[Exposure Compensation] slider

You can control the exposure.

Note

This cannot be set for [Image Stabilizer].

Setting the Camera Angle

You can operate pan, tilt, rotation and zoom

operations to set a desired camera angle.

You can operate zoom operation only.

Set Using the Operation Buttons and Sliders

Click each of the [Pan], [Tilt], [Rotation] buttons to set the

camera angle. Camera angle changes in orientation if the

button is held down, and stops when the button is

released.

To set rotation using the [Rotation] slider, drag the slider

and release the mouse button when the subject in the

image is shown at a level angle.

Important

You must set Intelligent Function detection areas, privacy

masks and presets again after changing settings in the Camera
Angle Setting Tool.

Pan (horizontal movement) operation

Tilt (vertical movement) operation

Rotation (angled movement) operation