Canon EOS 7D Mark II Wi-Fi Adapter Kit Manual

495

If a problem occurs with the camera, first refer to this Troubleshooting 
Guide. If this Troubleshooting Guide does not resolve the problem, 
contact your dealer or nearest Canon Service Center.

 

If the battery’s remaining capacity is 94% or higher, the battery will not 
be recharged (p.470).

 

Do not use any battery pack other than genuine Battery Pack LP-E6N/
LP-E6.

 

If (1) the battery charger or battery pack has a problem or (2) 
communication with the battery pack failed (with a non-Canon battery pack), 
the protection circuit will stop charging, and the charge lamp will blink in 
orange at a high speed. In the case of (1), unplug the charger’s power plug 
from the power outlet. Detach and reattach the battery pack to the charger. 
Wait a few minutes, then reconnect the power plug to the power outlet. If the 
problem persists, contact your dealer or nearest Canon Service Center.

 

If the internal temperature of the battery pack attached to the charger is 
high, the charger will not charge the battery for safety reasons (lamp 
off). During charging, if the battery’s temperature becomes high for any 
reason, charging will stop automatically (lamp blinks). When the battery 
temperature goes down, charging will resume automatically.

 

Make sure the battery compartment cover is closed 

(p.

)

.

 

Make sure the battery is installed properly in the camera (p.40).

 

Recharge the battery (p.38).

 

Make sure the card slot cover is closed 

)

.

The camera does not operate even when the power switch is set to <1>.