Olympus µ 810 Manual De Introducción

1

Press 

2Y. 

2

Press 

12 to select [Y ON], and press o.

3

Press the shutter button fully to take the picture.

  The self-timer lamp lights for approximately 10 seconds 

after the shutter button is pressed, then starts blinking. 
After blinking for approximately 2 seconds, the picture 
is taken.

1

Press 

3#.

2

Press 

12 to select the flash mode, and press o.

3

Press the shutter button halfway. 

  When the flash is set to fire, the 

# mark lights.

4

Press the shutter button completely to take the picture.
Flash working range:
W (max.): Approx. 5.2 m (17 ft.) 
T (max.): Approx. 3.2 m (10.4 ft.) 

  To save battery power, the camera automatically enters sleep mode and stops 

operating if not used for 3 minutes in shooting mode. Press the shutter button or 
zoom button to reactivate the camera.

  If the camera is not operated for 15 minutes after the camera enters sleep mode, 

it automatically retracts the lens and turns off. To resume operation, turn on the 
power again.

  If the camera has been used for a long time, the internal temperature of the 

camera may raise, stopping the operation automatically. In such a case, remove 
the battery from the camera and leave the camera until it becomes cool. The 
camera outside temperature is also raises during operation, but it is not a trouble.

Icon

Flash Mode

Description

No 

indication

Auto flash

The flash fires automatically in low light or backlight 
conditions.

!

Red-eye 
reduction flash

The red-eye reduction flash mode significantly reduces this 
phenomenon by emitting pre-flashes before firing the 
regular flash.

#

Fill-in flash

The flash fires regardless of the available light.

$

Flash off

The flash does not fire even in low light conditions.

Self-Timer Lamp

d4301_basic_e.book  Page 13  Friday, January 6, 2006  6:14 PM