Netgear M4100-D12G (GSM5212v1h1) - 10‐port GE + 2 GE Combo L2 Managed PD Switch Guía De Administador

The traffic class value range is 0–-6 instead of 0–-7 because queue 7 
is reserved in a stacking build for stack control, and therefore you 
cannot configure it.

Select QoS > CoS > Advanced > CoS Configuration. 

A screen similar to the following displays.

Under CoS Configuration, select the Interface radio button.

In the Interface list, select 1/0/3.

In the Interface Trust Mode list, select trust dot1p.

Click Apply to save the settings.

Traffic shaping controls the amount and volume of traffic transmitted through a network. This 
has the effect of smoothing temporary traffic bursts over time. Use the traffic-shape command 
to enable traffic shaping by specifying the maximum transmission bandwidth limit for all 
interfaces (Global Config) or for a single interface (Interface Config). 

The <bw> value is a percentage that ranges from 0 to 100 in increments of 5. The default 
bandwidth value is 0, meaning no upper limit is enforced, which allows the interface to 
transmit up to its maximum line rate. 

The bw value is independent of any per-queue maximum bandwidth values in effect for the 
interface and should be considered as a second-level transmission rate control mechanism 
that regulates the output of the entire interface regardless of which queues originate the 
outbound traffic.