Netgear M4100-D12G (GSM5212v1h1) - 10‐port GE + 2 GE Combo L2 Managed PD Switch Guía De Administador

This section describes the traceroute feature. Use traceroute to discover routes that packets 
take when traveling on a hop-by-hop basis to their destination through the network. 

Traceroute maps network routes by sending packets with small time-to-live (TTL) values 
and watches the ICMP time-out announcements.

The traceroute command displays all L3 devices.

It can be used to detect issues on the network.

Traceroute tracks up to 20 hops.

The default UPD port is used 33343 unless you specify otherwise in the traceroute 
command.

The following shows an example of using the traceroute command to determine how 
many hops there are to the destination. The command output shows each IP address the 
packet passes through and how long it takes to get there. In this example, the packet takes 
16 hops to reach its destination.

(Netgear Switch) #traceroute?

<ipaddr> 

 

    Enter IP address.

(Netgear Switch) #traceroute 216.109.118.74 ?

<cr>    Press Enter to execute the command.

<port>        Enter port no.    

(Netgear Switch) #traceroute 216.109.118.74

tracing route over a maximum of 20 hops

1  10.254.24.1        40 ms       9 ms      10 ms

 2  10.254.253.1       30 ms      49 ms      21 ms

 3  63.237.23.33       29 ms      10 ms      10 ms

 4  63.144.4.1         39 ms      63 ms      67 ms

 5  63.144.1.141       70 ms      50 ms      50 ms

 6  205.171.21.89      39 ms      70 ms      50 ms

 7  205.171.8.154      70 ms      50 ms      70 ms

 8  205.171.8.222      70 ms      50 ms      80 ms

 9  205.171.251.34     60 ms      90 ms      50 ms

10  209.244.219.181    60 ms      70 ms      70 ms

11  209.244.11.9       60 ms      60 ms      50 ms

12  4.68.121.146       50 ms      70 ms      60 ms

13  4.79.228.2         60 ms      60 ms      60 ms

14  216.115.96.185    110 ms      59 ms      70 ms

15  216.109.120.203    70 ms      66 ms      95 ms

16  216.109.118.74     78 ms     121 ms      69 ms