Netgear M4100-50G (GSM7248v2h2) - 46‐port GE + 4 GE Combo L2 Managed Switch Guía Del Software

command without the keyword no to reenable a disabled feature or to enable a feature that 
is disabled by default. Only the configuration commands are available in the no form.

Managed switch software consists of flexible modules that can be applied in various 
combinations to develop advanced Layer 2/3/4+ products. The commands and command 
modes available on your switch depend on the installed modules. Additionally, for some 
show

 commands, the output fields might change based on the modules included in the 

software.

The software suite includes the following modules:

Switching (Layer 2)

Routing (Layer 3)

Quality of Service

Management (CLI, web UI, and SNMP)

The CLI groups commands into modes according to the command function. Each of the 
command modes supports specific software commands. The commands in one mode are 
not available until you switch to that particular mode, except for the User EXEC mode 
commands. You can execute the User EXEC mode commands in the Privileged EXEC 
mode.

The command prompt changes in each command mode to help you identify the current 
mode. The following table describes the command modes and the prompts visible in that 
mode.

The command modes available on your switch depend on the software 
modules that are installed. For example, a switch that does not support 
BGPv4 does not provide the Router BGPv4 Command Mode.

User EXEC

Switch>

Contains a limited set of commands to view 
basic system information.

Privileged EXEC

Switch#

Allows you to issue any EXEC command, 

enter the VLAN mode, or enter the Global 
Configuration mode.