Netgear M4100-50G (GSM7248v2h2) - 46‐port GE + 4 GE Combo L2 Managed Switch Manual De Usuario

Use STP Mode to enable or disable the Spanning Tree Protocol administrative mode 
associated with the LAG. 

The possible values are as follows:

Disable —

  Spanning tree is disabled for this LAG.

Enable —

  Spanning tree is enabled for this LAG.

Use Static Mode to select enable or disable. 

When the LAG is enabled, it does not transmit or process received LACPDUs, for 
example, the member ports do not transmit LACPDUs and all the LACPDUs it can 
receive are dropped. The factory default is disabled.

Use Link Trap to specify whether a trap is sent when link status changes. 

The factory default is enabled, which causes the trap to be sent.

Click the APPLY button.

The settings are sent to the switch. Configuration changes take effect immediately. These 
changes are not retained across a power cycle unless you save the configuration. See 

The following table describes the nonconfigurable information displayed on the screen.

LAG Description

Enter the description string to be attached to a LAG. It can be up to 64 
characters in length.

LAG ID

Identification of the LAG.

Configured Ports

Indicate the ports that are members of this port channel.

Active Ports

Indicates the ports that are actively participating in the port channel.

LAG State

Indicates whether the Link is up or down.

You can select two or more full-duplex Ethernet links to be aggregated together to form a link 
aggregation group (LAG), which is also known as a port channel. The switch can treat the 
port channel as if it were a single link.



Prepare your computer with a static IP address in the 169.254.100.0 subnet, for 
example, 169.254.100.201.

Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on 
the switch.

Launch a web browser.

Enter the IP address of the switch in the web browser address field.