Netgear M4100-50G (GSM7248v2h2) - 46‐port GE + 4 GE Combo L2 Managed Switch Manual De Hardware
24
3
3.
Troubleshooting
Troubleshooting Chart
The following table lists symptoms, causes, and solutions to possible problems.
Table 3. Troubleshooting chart
Problem
Cause
Solution
Power LED is off.
No power is received.
Check the power cord connections for the switch
at the switch and the connected device.
at the switch and the connected device.
Make sure that all cables used are correct and
comply with Ethernet specifications.
comply with Ethernet specifications.
Link LED is off or intermittent. Port connection is not
working.
•
Check the crimp on the connectors. Make
sure that the plug is fully inserted and locked
into the port at both the switch and the
connecting device.
sure that the plug is fully inserted and locked
into the port at both the switch and the
connecting device.
•
Make sure that all cables used are correct
and comply with Ethernet specifications.
See
and comply with Ethernet specifications.
See
•
Check for a defective adapter card, cable, or
port by testing it in an alternate environment
where all products are functioning.
port by testing it in an alternate environment
where all products are functioning.
Slow file transfer or there is
performance degradation.
performance degradation.
Half- or full-duplex setting on
the switch and the connected
device are not the same.
the switch and the connected
device are not the same.
•
Make sure that the attached device is set to
autonegotiate.
autonegotiate.
•
Check the system message log.
A segment or device is not
recognized as part of the
network.
network.
One or more devices are not
properly connected, or cabling
does not meet Ethernet
guidelines.
properly connected, or cabling
does not meet Ethernet
guidelines.
Verify that the cabling is correct. Be sure that all
connectors are securely positioned in the
required ports. Equipment might have been
accidentally disconnected.
connectors are securely positioned in the
required ports. Equipment might have been
accidentally disconnected.
ACT LED blinks continuously
on all connected ports and the
network is disabled.
network is disabled.
A network loop (redundant
path) has been created.
Break the loop by ensuring that there is only one
path from any networked device to any other
networked device.
path from any networked device to any other
networked device.