Netgear M4100-50G (GSM7248v2h2) - 46‐port GE + 4 GE Combo L2 Managed Switch Guía De Administador
DiffServ
146
ProSAFE M4100 Managed Switches
4.
Attach the defined policy to interfaces 1/0/1 through 1/0/4 in the inbound direction.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/1)#exit
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/4)#exit
5.
Set the CoS queue configuration for the (presumed) egress interface 1/0/5 such that each of
queues 1, 2, 3, and 4 gets a minimum guaranteed bandwidth of 25 percent. All queues for
this interface use weighted round robin scheduling by default. The DiffServ inbound policy
designates that these queues are to be used for the departmental traffic through the
assign-queue attribute. It is presumed that the switch will forward this traffic to interface 1/0/5
based on a normal destination address lookup for Internet traffic.
queues 1, 2, 3, and 4 gets a minimum guaranteed bandwidth of 25 percent. All queues for
this interface use weighted round robin scheduling by default. The DiffServ inbound policy
designates that these queues are to be used for the departmental traffic through the
assign-queue attribute. It is presumed that the switch will forward this traffic to interface 1/0/5
based on a normal destination address lookup for Internet traffic.
(Netgear Switch) (Config)#interface 1/0/5
(Netgear Switch) (Interface 1/0/5)#cos-queue min-bandwidth 0 25 25 25 25 0 0 0
(Netgear Switch) (Interface 1/0/5)#exit
(Netgear Switch) (Config)#exit
Web Interface: Configure DiffServ
1.
Enable Diffserv.
a. Select QoS > DiffServ > Basic > DiffServ Configuration.
A screen similar to the following displays.
b. For Diffserv Admin Mode, select the Enable radio button.
c. Click Apply to save the settings.