Netgear XS716T – ProSAFE® 10 Gigabit Smart Managed Switch Manual De Hardware

The following figure shows the back panel of model XS708T.

The back panel contains a Kensington™ lock slot and the AC power connector. The serial 
console port is not for customer use.

The following table describes the RJ-45 and SFP+ slot LED designations. Each RJ-45 port 
provides a left LED and a right LED and each SFP+ slot provides two LEDs.

Power 

Solid green .    The  device  is  powered  on.

Solid yellow .  The  device  is  booting.

Off .  Power is not supplied to the device.

Fan

Solid yellow .  A  fan  failure  occurred.

Off .    The  fan  is  operating  normally.

Speed/ACT LEDs for copper 
ports 1 to 8

Off.  No  link  is  established.

Solid green (left LED).  A valid 10 Gbps link is established.

Blinking green (left LED).  The port is transmitting or receiving packets at 
10 Gbps.

Solid yellow (right LED) .  A valid 100/1000 Mbps link is established.

Blinking yellow (right LED).  The port is transmitting or receiving traffic 
at 100/1000 Mbps.

Link/ACT LEDs for SFP+ slots 
7F and 8F

10G LED:

Off .  No SFP+ module is inserted or no module link is established.

Solid .  A  valid  10  Gbps  link  is  established.

Blinking.   The  module  is  transmitting  or  receiving  packets  at 10 Gbps.

1G LED:

Off .  No SFP+ module is inserted or no module link is established.

Solid .  A valid 1 Gbps link is established.

Blinking.   The  module  is  transmitting  or  receiving  packets  at 1 Gbps.