Netgear XS716T – ProSAFE® 10 Gigabit Smart Managed Switch Manual De Hardware
Hardware Overview
15
ProSAFE 8-Port and 16-Port 10-Gigabit Smart Managed Switch Models XS708T and XS716T
Switch Hardware Interfaces
The following sections describe the hardware interfaces on the switch.
100M/1G/10G RJ-45 Ports
All copper RJ-45 ports support AutoSensing. When you insert a cable into an RJ-45 port, the
switch automatically ascertains the maximum speed (100 Mbps, 1 Gbps, or 10 Gbps) and
duplex mode (half-duplex or full-duplex) of the attached device. All ports support a Category
5e (Cat 5e) unshielded twisted-pair (UTP) cable or higher rated Ethernet cable terminated
with an 8-pin RJ-45 connector.
duplex mode (half-duplex or full-duplex) of the attached device. All ports support a Category
5e (Cat 5e) unshielded twisted-pair (UTP) cable or higher rated Ethernet cable terminated
with an 8-pin RJ-45 connector.
To simplify the procedure for attaching devices, all RJ-45 ports support Auto Uplink. This
technology allows attaching devices to the RJ-45 ports with either straight-through or
crossover cables.
technology allows attaching devices to the RJ-45 ports with either straight-through or
crossover cables.
Note:
For 10GBASE-T ports, Ethernet specifications limit a Category 6
(Cat 6) cable length between the switch and the attached device to
328 feet (100 meters).
(Cat 6) cable length between the switch and the attached device to
328 feet (100 meters).
When you insert a cable into the switch’s RJ-45 port, the switch automatically performs the
following actions:
following actions:
•
Senses whether the cable is a straight-through or crossover cable.
•
Determines whether the link to the attached device requires a normal connection (such
as when you are connecting the port to a computer) or an uplink connection (such as
when you are connecting the port to a router, switch, or hub).
as when you are connecting the port to a computer) or an uplink connection (such as
when you are connecting the port to a router, switch, or hub).
•
Automatically configures the RJ-45 port to enable communications with the attached
device. The Auto Uplink technology compensates for setting uplink connections while
eliminating concern about whether to use crossover or straight-through cables when you
attach devices.
eliminating concern about whether to use crossover or straight-through cables when you
attach devices.
1000/10GBASE-X SFP+ Slots
To enable high-speed fiber, copper, and long-distance connections on the switch, SFP+ slots
accommodate standard 10G and 1G SFP+ transceiver modules, which are sold separately.
accommodate standard 10G and 1G SFP+ transceiver modules, which are sold separately.
The switch supports most NETGEAR ProSAFE SFP and SFP+ transceiver modules and
Direct Attach Cables (DAC), including:
Direct Attach Cables (DAC), including:
•
Short-reach transceiver modules
•
Long-reach transceiver modules
For information about specific NETGEAR ProSAFE SFP and SFP+ transceiver modules and
cables that are supported for the switch, visit
cables that are supported for the switch, visit
and click the MODULES AND ACCESSORIES tab, or see the datasheet for your specific
switch.
switch.