Netgear XS716T – ProSAFE® 10 Gigabit Smart Managed Switch Manual De Hardware
Installation
25
ProSAFE 8-Port and 16-Port 10-Gigabit Smart Managed Switch Models XS708T and XS716T
Step 5: Check the Installation
Before you apply power to the switch, perform the steps that are described in this section.
To check the installation:
1.
Inspect the equipment thoroughly.
2.
Verify that all cables are installed correctly.
3.
Check cable routing to make sure that cables are not damaged or creating a safety hazard.
4.
Ensure that all equipment is mounted properly and securely.
Optional Step 6: Install an SFP Transceiver Module
The following procedure describes how to install an optional SFP (or SFP+) transceiver
module into one of the SFP slots of the switch. You can install up to two modules.
module into one of the SFP slots of the switch. You can install up to two modules.
Note:
Contact your NETGEAR sales office to buy these modules. If you do
not want to install an SFP module, skip this procedure.
not want to install an SFP module, skip this procedure.
To install an SFP or SFP+ transceiver module:
1.
Insert the transceiver module into an SFP+ slot.
On model XS708T, insert the module in slot 7F or 8F (each slot can accept a module).
On model XS716T, insert the module in slot 15F or 16F (each slot can accept a module).
On model XS716T, insert the module in slot 15F or 16F (each slot can accept a module).
2.
Press firmly on the flange of the module to seat it securely into the connector.
Figure 10. Installing a transceiver module (model XS708T shown)
Tx
Rx