Netgear FVS318N – Prosafe Wireless N VPN Firewall Prospecto

IPv4 Add Firewall Rule and Edit Firewall Rule Commands

This command configures a new IPv4 LAN WAN outbound firewall rule. After you have 
issued the security firewall ipv4 add_rule lan_wan outbound command, you 
enter the security-config [firewall-ipv4-lan-wan-outbound] mode, and then you can configure 
one keyword and associated parameter or associated keyword at a time in the order that you 
prefer. However, note that the setting of the action keyword determines which other 
keywords and parameters can you can apply to a rule.

security

bandwidth_profile <profile name>

security-config [firewall-ipv4-lan-wan-outbound]

security firewall ipv4 add_rule lan_wan outbound 

service_name {default_services <default service name> | 

   {custom_services <custom service name>}

action {ALWAYS_BLOCK | ALWAYS_ALLOW | 

   BLOCK_BY_SCHEDULE_ELSE_ALLOW {schedule {Schedule1 | 

   Schedule2 | Schedule3}} | ALLOW_BY_SCHEDULE_ELSE_BLOCK 

   {schedule {Schedule1 | Schedule2 | Schedule3}}}

lan_users {address_wise {ANY | SINGLE_ADDRESS {lan_user_start_ip 

   <ipaddress>} | ADDRESS_RANGE {lan_user_start_ip <ipaddress>} 

   {lan_user_end_ip <ipaddress>}} | group_wise <group name>}

wan_users {ANY | SINGLE_ADDRESS {wan_user_start_ip <ipaddress>} 

   | ADDRESS_RANGE {wan_user_start_ip <ipaddress>} 

   {wan_user_end_ip <ipaddress>}}

qos_priority {Normal-Service | Minimize-Cost |  

   Maximize-Reliability | Maximize-Throughput | Minimize-Delay}

log {NEVER | ALWAYS}

nat_ip type {WAN_INTERFACE_ADDRESS | SINGLE_ADDRESS 

   {address <ipaddress>}}