Netgear GSM7228PS - ProSAFE 28 ports Gigabit Ethernet L2 Managed Stackable Switch with PoE Guía De Administador
44
|
Chapter 4. Port Routing
ProSafe 7000 Managed Switch Release 8.0.3
•
In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
Add a Default Route
When IP routing takes place on a switch, a routing table is needed for the switch to forward
the packet based on the destination IP address. The route entry in the routing table can either
be created dynamically through routing protocols like RIP and OSPF, or be manually created
by the network administrator. The route created manually is called the static or default route.
the packet based on the destination IP address. The route entry in the routing table can either
be created dynamically through routing protocols like RIP and OSPF, or be manually created
by the network administrator. The route created manually is called the static or default route.
A default route is used for forwarding the packet when the switch can not find a match in the
routing table for an IP packet. The following example shows how to create a default route.
routing table for an IP packet. The following example shows how to create a default route.
CLI: Add a Default Route
(FSM7338S) (Config) #ip route default?
<nexthopip> Enter the IP Address of the next router.
(FSM7328S) (Config)#ip route default 10.10.10.2
52).
Web Interface: Add a Default Route
1.
Select Routing > Routing Table > Basic > Route Configuration. The Route
Configuration screen displays.
Configuration screen displays.
2.
In the Route Type list, select DefaultRoute.
3.
In the Next Hop IP Address field, enter one of the routing interface’s IP addresses.
•
The Network Address and Subnet Mask fields will not accept input as they are not
needed.