Netgear GSM7228PS - ProSAFE 28 ports Gigabit Ethernet L2 Managed Stackable Switch with PoE Guía De Administador
Chapter 6. RIP
|
57
ProSafe 7000 Managed Switch Release 8.0.3
2.
Assign IP address 192.150.3.1/24 to interface 1/0/3.
a. Select Routing > Advanced >IP Interface Configuration. A screen similar to the
following displays.
b. Scroll down and select the interface 1/0/3 check box. Now 1/0/3 appears in the
Interface field at the top.
c. Enter the following information:
•
In the IP Address field, enter 192.150.3.1.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
RIP for the Switch
Note:
Unless you have previously disabled RIP, you can skip this step
since RIP is enabled by default.
CLI: Enable RIP on the Switch
This sequence enables RIP for the switch. The route preference defaults to 15.
(Netgear Switch) #config
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit