Netgear GSM7228PS - ProSAFE 28 ports Gigabit Ethernet L2 Managed Stackable Switch with PoE Guía De Administador

c.  Scroll down and select the interface 0/2/2 check box. Now 0/2/2 appears in the 

Interface field at the top.

d.  Enter the following information:

In the OSPF Area ID field, enter 0.0.0.3.

In the OSPF Admin Mode field, select the Enable.

In the Priority field, enter 255.

In the Metric Cost field, enter 64.

e.  Click Apply to save the settings.

OSPFv3

OSPFv3 is the Open Shortest Path First routing protocol for IPv6. It is similar to OSPFv2 in its 
concept of a link state database, intra- and inter-area, and AS external routes and virtual 
links. It differs from its IPv4 counterpoint in a number of respects, including the following: 
Peering is done through link-local addresses; the protocol is link based rather than network 
based; and addressing semantics have been moved to leaf LSAs, which eventually allow its 
use for both IPv4 and IPv6. Point-to-point links are also supported in order to enable 
operation over tunnels. It is possible to enable OSPF and OSPFv3 at the same time. OSPF 
works with IPv4, and OSPFv3 works with IPv6. The following example shows how to 
configure OSPFv3 on a IPv6 network. 

Area 0

Switch A2

Switch A1

CLI: Configure OSPFv3

On A1, enable IPv6 unitcast routing on the switch.

(Netgear Switch) (Config)#ipv6 unicast-routing