Netgear WAC730- ProSAFE® Business 3 x 3 Dual Band Wireless-AC Access Point Manual De Usuario
Initial Setup
28
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
9.
Click the Apply button.
Your settings are saved.
Note:
For information about how to configure advanced WiFi settings, see
Test Basic WiFi Connectivity
After you configure the access point, make sure that WiFi devices can connect to the access
point before you position and mount the access point at its permanent position.
To test for WiFi connectivity:
1.
Configure your WiFi devices so that they can connect to a WiFI network that you
configured on the access point.
configured on the access point.
2.
Verify that your WiFi devices acquired a WiFi link to the access point.
3.
Verify network connectivity by using a browser to connect to the Internet, or check for file
and printer access on your network.
and printer access on your network.
Note:
If you experience trouble connecting to the access point, see
We recommend that you complete the following tasks before you deploy the access point in
your network:
your network:
•
•
, and
.
After you complete the configuration of the access point, you can reconfigure the computer
that you used for this process back to its original TCP/IP settings.
Output Power
From the menu, select the transmission power of the access point: Full, Half,
Quarter, Eighth, Minimum. The default is Full.
Quarter, Eighth, Minimum. The default is Full.
Note:
Increasing the power improves performance, but if two or more access
points are operating in the same area and on the same channel, interference can
occur.
occur.
Note:
Make sure that you comply with the regulatory requirements for total radio
frequency (RF) output power in your country.
Setting
Descriptions