Netgear M4100-D12G (GSM5212v1h1) - 10‐port GE + 2 GE Combo L2 Managed PD Switch Guía Del Software
Routing Commands
234
M4100 Series ProSAFE
Managed
Switches
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the
switch.
switch.
routing
This command enables IPv4 and IPv6 routing for an interface. You can view the current value
for this function with the show ip brief command. The value is labeled as “Routing
Mode.”
for this function with the show ip brief command. The value is labeled as “Routing
Mode.”
no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The
value is labeled as “Routing Mode.”
value is labeled as “Routing Mode.”
ip routing
This command enables the IP Router Admin Mode for the master switch.
no ip routing
This command disables the IP Router Admin Mode for the master switch.
ip address
This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface. The command supports
RFC 3021 and accepts using 31-bit prefixes on IPv4 point-to-point links. This command adds
the label IP address in show ip interface.
configure one or more secondary IP addresses on the interface. The command supports
RFC 3021 and accepts using 31-bit prefixes on IPv4 point-to-point links. This command adds
the label IP address in show ip interface.
Default
disabled
Format
routing
Mode
Interface Config
Format
no routing
Mode
Interface Config
Format
ip routing
Mode
Global Config
Format
no ip routing
Mode
Global Config