Netgear M4100-D12G (GSM5212v1h1) - 10‐port GE + 2 GE Combo L2 Managed PD Switch Guía Del Software

This command displays IP ACLs, IPv6 ACLs, and MAC access control lists information for a 
designated interface and direction.

This section describes the commands you use to configure IPv6 ACL settings. IPv6 ACLs 
ensure that only authorized users have access to specific resources and block any 
unwarranted attempts to reach network resources. 

The following rules apply to IPv6 ACLs:

The maximum number of ACLs you create is 100, regardless of type.

The system supports only Ethernet II frame types.

The maximum number of rules per IPv6 ACL is hardware-dependent.

Log 

Displays when you enable logging for the rule.

Assign Queue

The queue identifier to which packets matching this rule are assigned.

Mirror Interface

The slot/port to which packets matching this rule are copied.

Redirect 
Interface

The slot/port to which packets matching this rule are forwarded.

Time Range 
Name 

Displays the name of the time-range if the ACL rule has referenced a time range.

Rule Status

Status (Active/Inactive) of the ACL rule.

Format

show access-lists interface <slot/port> [in | out] 

Mode

Privileged EXEC

ACL Type

Type of access list (IP, IPv6, or MAC).

ACL ID

Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access 

list.

Sequence 
Number

An optional sequence number might be specified to indicate the order of this access list 

relative to other access lists already assigned to this interface and direction. A lower 
number indicates higher precedence order. If a sequence number is already in use for 
this interface and direction, the specified access list replaces the currently attached 
access list using that sequence number. If the sequence number is not specified by the 
user, a sequence number that is one greater than the highest sequence number currently 
in use for this interface and direction is used. Valid range is (1–4,294,967,295).