Netgear M4100-D12G (GSM5212v1h1) - 10‐port GE + 2 GE Combo L2 Managed PD Switch Guía Del Software
Management Commands
444
M4100 Series ProSAFE
Managed
Switches
Switch Management CPU Commands
To manage the switch via the web GUI or telnet, an IP address needs to be assigned to the
switch management CPU. Whereas there are CLI commands that can be used to do this,
ezconfig simplifies the task. The tool allows you to configure the following parameters:
switch management CPU. Whereas there are CLI commands that can be used to do this,
ezconfig simplifies the task. The tool allows you to configure the following parameters:
1.
The administrator’s user password and administrator-enable password
2.
Management CPU IP address and network mask
3.
System name and location information
The tool is interactive and uses questions to guide you through the steps required to perform
its task. At the end of the session, it will ask you if you want to save the changed information.
To see exactly what has been changed by ezconfig at the end of the session, use the show
running-config command.
its task. At the end of the session, it will ask you if you want to save the changed information.
To see exactly what has been changed by ezconfig at the end of the session, use the show
running-config command.
To perform any switch configuration other than the items listed above, use other CLI
commands or the web GUI.
commands or the web GUI.
ezconfig
This command sets the IP address, subnet mask, and gateway of the device. The IP address
and the gateway must be on the same subnet.
and the gateway must be on the same subnet.
Format
ezconfig
Mode
Privileged EXEC