Netgear M4100-D12G (GSM5212v1h1) - 10‐port GE + 2 GE Combo L2 Managed PD Switch Guía Del Software

This section describes the commands you use to configure and view Telnet settings. You can 
use Telnet to manage the device from a remote management host.

Use this command to enable Telnet connections to the system and to enable the Telnet 
Server Admin Mode. This command opens the Telnet listening port. 

Use this command to disable Telnet access to the system and to disable the Telnet Server 

Admin Mode. This command closes the Telnet listening port and disconnects all open Telnet 

sessions. 

Use this command to establish a new outbound Telnet connection to a remote host. The host 
must be a valid IP address or host name. The value for <port> is a valid decimal integer in 
the range of 0–65,535, where the default value is 23. If the optional debug parameter is 
used, the current Telnet options enabled is displayed. The optional line parameter sets the 
outbound Telnet operational mode as linemode (by default, the operational mode is character 
mode). The optional noecho parameter disables local echo.

Privileged EXEC

User EXEC

Stop Bits

The number of Stop bits per character. The number of Stop bits is always 1.

Parity Type

The parity method used on the serial port. The parity method is always None.

Default

enabled

Format

ip telnet server enable

Mode

Privileged EXEC

Format

no ip telnet server enable

Mode

Privileged EXEC

Format

telnet {<ip-address> | <hostname>} <port> [debug] [line] [noecho]

Modes