Netgear M4100-12GF (GSM7212F) - ProSAFE Gigabit L2+ Managed Switch Guía Del Software
Switching Commands
129
M4100 Series ProSAFE
Managed
Switches
Static MAC Filtering Commands
The commands in this section describe how to configure static MAC filtering. Static MAC
filtering allows you to configure destination ports for a static multicast MAC filter irrespective
of the platform.
filtering allows you to configure destination ports for a static multicast MAC filter irrespective
of the platform.
macfilter
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN
<vlanid>
<vlanid>
. A packet with a specific destination MAC address in a specific VLAN is admitted
only if the ingress port is defined in the set of source ports, otherwise the packet is dropped.
On the egress side, a packet that was admitted is sent through all ports that are defined in
the set of destination ports.
On the egress side, a packet that was admitted is sent through all ports that are defined in
the set of destination ports.
The value of the <macaddr> parameter is a 6-byte hexadecimal number in the format of
b1:b2:b3:b4:b5:b6. The following MAC addresses are restricted: 00:00:00:00:00:00,
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN.
b1:b2:b3:b4:b5:b6. The following MAC addresses are restricted: 00:00:00:00:00:00,
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where
source ports are configured and MAC filters where destination ports are configured.
source ports are configured and MAC filters where destination ports are configured.
•
For unicast MAC address filters and multicast MAC address filters with source port lists,
the maximum number of static MAC filters supported is 20.
the maximum number of static MAC filters supported is 20.
•
For multicast MAC address filters with destination ports configured, the maximum number
of static filters supported is 256.
of static filters supported is 256.
For example, for current platforms you can configure the following combinations:
•
Unicast MAC and source port (max = 20)
•
Multicast MAC and source port (max=20)
•
Multicast MAC and destination port (only) (max=256)
•
Multicast MAC and source ports and destination ports (max=20)
no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the MAC
address <macaddr> on the VLAN <vlanid>. The <macaddr> parameter must be specified
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
address <macaddr> on the VLAN <vlanid>. The <macaddr> parameter must be specified
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
macfilter <macaddr> <vlanid>
Mode
Global Config
Format
no macfilter <macaddr> <vlanid>
Mode
Global Config