Netgear M4100-12GF (GSM7212F) - ProSAFE Gigabit L2+ Managed Switch Guía Del Software
Using the Command-Line Interface
16
M4100 Series ProSAFE
Managed
Switches
Enter a question mark (?) after each word you enter to display available command keywords
or parameters.
or parameters.
(NETGEAR Switch) #network ?
javamode Enable/Disable.
mgmt_vlan Configure the Management VLAN ID of the switch.
parms Configure Network Parameters of the router.
protocol Select DHCP, BootP, or None as the network config
protocol.
If the help output shows a parameter in angle brackets, you must replace the parameter with
a value.
a value.
(NETGEAR Switch) #network parms ?
<ipaddr> Enter the IP address.
If there are no additional command keywords or parameters, or if more parameters are
optional, the following message appears in the output:
optional, the following message appears in the output:
<cr> Press Enter to execute the command
You can also enter a question mark (?) after typing one or more characters of a word to list
the available command or parameters that begin with the letters, as shown in the following
example:
the available command or parameters that begin with the letters, as shown in the following
example:
(NETGEAR Switch) #show m?
mac-addr-table mac-address-table monitor
Accessing the CLI
You can access the CLI by using a direct console connection or by using a telnet or SSH
connection from a remote management host.
connection from a remote management host.
For the initial connection, you must use a direct connection to the console port. You cannot
access the system remotely until the system has an IP address, subnet mask, and default
gateway. You can set the network configuration information manually, or you can configure
the system to accept these settings from a BOOTP or DHCP server on your network. For
more information, see
access the system remotely until the system has an IP address, subnet mask, and default
gateway. You can set the network configuration information manually, or you can configure
the system to accept these settings from a BOOTP or DHCP server on your network. For
more information, see
446.