Netgear M4100-12GF (GSM7212F) - ProSAFE Gigabit L2+ Managed Switch Guía Del Software
Switching Commands
19
M4100 Series ProSAFE
Managed
Switches
Port Configuration Commands
This section describes the commands you use to view and configure port settings.
interface
This command gives you access to the Interface Config mode, which allows you to enable or
modify the operation of an interface (port).
modify the operation of an interface (port).
interface vlan
This command gives you access to the vlan virtual interface mode, which allows certain port
configurations (for example, the IP address) to be applied to the VLAN interface. Type a
question mark (?) after entering the interface configuration mode to see the available options.
configurations (for example, the IP address) to be applied to the VLAN interface. Type a
question mark (?) after entering the interface configuration mode to see the available options.
interface lag
This command gives you access to the LAG (link aggregation, or port channel) virtual
interface, which allows certain port configurations to be applied to the LAG interface. Type a
question mark (?) after entering the interface configuration mode to see the available options.
interface, which allows certain port configurations to be applied to the LAG interface. Type a
question mark (?) after entering the interface configuration mode to see the available options.
Note:
The IP address cannot be assigned to a LAG virtual interface. The
interface must be put under a VLAN group and an IP address
assigned to the VLAN group.
interface must be put under a VLAN group and an IP address
assigned to the VLAN group.
auto-negotiate
This command enables automatic negotiation on a port.
Format
interface <slot/port>
Mode
Global Config
Format
interface vlan <vlan id>
Mode
Global Config
Format
interface lag <lag id>
Mode
Global Config
Default
enabled
Format
auto-negotiate
Mode
Interface Config