Netgear M4100-12GF (GSM7212F) - ProSAFE Gigabit L2+ Managed Switch Guía Del Software

Inventory

Hardware Rev: xxx xxx xxx

Firmware Rev: xxx xxx xxx

Software Rev: xxx xxx xxx

Serial Num: xxx xxx xxx

Mfg Name: xxx xxx xxx 

Model Name: xxx xxx xxx

Asset ID: xxx xxx xxx 

Location

Subtype: elin

Info: xxx xxx xxx

Extended POE

Device Type: pseDevice

Extended POE PSE

Available: 0.3 Watts

Source: primary

Priority: critical

Extended POE PD

Required: 0.2 Watts

Source: local

Priority: low

This section describes the commands you use to configure Denial of Service (DoS) Control. 
The software provides support for classifying and blocking specific types of Denial of Service 
attacks. You can configure your system to monitor and block these types of attacks:

SIP=DIP: Source IP address = Destination IP address.

First Fragment: TCP Header size smaller then configured value.

TCP Fragment: IP Fragment Offset = 1.

TCP Flag: TCP Flag SYN set and Source Port < 1024 or TCP Control Flags = 0 and TCP 
Sequence Number = 0 or TCP Flags FIN, URG, and PSH set and TCP Sequence 
Number = 0 or TCP Flags SYN and FIN set.

L4 Port: Source TCP/UDP Port = Destination TCP/UDP Port.

ICMP: Limiting the size of ICMP Ping packets.

SMAC = DMAC: Source MAC address = Destination MAC address.

TCP Port: Source TCP Port = Destination TCP Port.