Netgear M4100-12GF (GSM7212F) - ProSAFE Gigabit L2+ Managed Switch Guía Del Software
Utility Commands
331
M4100 Series ProSAFE
Managed
Switches
no boot host retry-count
This command is used to reset the number to the default. The default number is 3.
boot host dhcp
This command is used to enable AutoInstall on the switch for the next reboot cycle. The
command does not change the current behavior of AutoInstall and saves the command to
NVRAM.
command does not change the current behavior of AutoInstall and saves the command to
NVRAM.
no boot host dhcp
This command is used to disable AutoInstall on the switch for the next reboot cycle. The
command does not change the current behavior of AutoInstall and saves the command to
NVRAM
command does not change the current behavior of AutoInstall and saves the command to
NVRAM
erase startup-config
Use this command to erase the text-based configuration file stored in non-volatile memory. If
the switch boots and no startup-config file is found, the AutoInstall process automatically
begins.
the switch boots and no startup-config file is found, the AutoInstall process automatically
begins.
Dual Image Commands
The software supports a dual image feature that allows the switch to have two software
images in the permanent storage. You can specify which image is the active image to be
loaded in subsequent reboots. This feature allows reduced down-time when you upgrade or
downgrade the software.
images in the permanent storage. You can specify which image is the active image to be
loaded in subsequent reboots. This feature allows reduced down-time when you upgrade or
downgrade the software.
Format
no boot host retry-count
Mode
Privileged EXEC
Default
Enabled
Format
boot host dhcp
Mode
Privileged EXEC
Format
no boot host dhcp
Mode
Privileged EXEC
Format
erase startup-config
Mode
Privileged EXEC