Netgear M4100-12GF (GSM7212F) - ProSAFE Gigabit L2+ Managed Switch Guía Del Software
Utility Commands
375
M4100 Series ProSAFE
Managed
Switches
Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system time
and date by using SNTP.
and date by using SNTP.
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
where <poll-interval> can be a value from 6 to 10.
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and might set the
mode to either broadcast or unicast.
mode to either broadcast or unicast.
no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Default
6
Format
sntp broadcast client poll-interval <poll-interval>
Mode
Global Config
Format
no sntp broadcast client poll-interval
Mode
Global Config
Default
disabled
Format
sntp client mode [broadcast | unicast]
Mode
Global Config
Format
no sntp client mode
Mode
Global Config