Netgear M4100-12GF (GSM7212F) - ProSAFE Gigabit L2+ Managed Switch Guía De Administador
SNTP
263
ProSAFE M4100 Managed Switches
2.
After configuring the IP address, enable SNTP client mode. The client mode can be either
broadcast mode or unicast mode. If the NTP server is not your own, you must use unicast
mode.
mode.
(Netgear Switch) (Config)#sntp client mode unicast
3.
Once SNTP client mode is enabled, the client waits for the polling interval to send the query
to the server. The default value is approximately 1 minute. After this period, issue the show
command to confirm that the time has been received. The time will be used in all logging
messages.
to the server. The default value is approximately 1 minute. After this period, issue the show
command to confirm that the time has been received. The time will be used in all logging
messages.
(Netgear Switch) #show sntp server
Server IP Address:
208.14.208.19
Server Type: ipv4
Server Stratum: 4
Server Reference Id:
NTP Srv: 208.14.208.3
Server Mode: Server
Server Maximum Entries: 3
Server Current Entries: 1
SNTP Servers
------------
IP Address: 208.14.208.19
Address Type: IPV4
Priority: 1
Version: 4
Port: 123
Last Update Time: Mar 26 03:36:09 2006
Last Attempt Time: Mar 26 03:36:09 2006
Last Update Status: Success
Total Unicast Requests: 2
Failed Unicast Requests: 0
Web Interface: Configure SNTP
1.
Configure the SNTP server.
a. Select System > Management >Time > SNTP Server Configuration.