KitchenAid 22 cu. ft. 33-Inch Width Full Depth Non Dispense Bottom Mount Refrigerator Uso Y Cuidado

1. Create a service loop (minimum diameter of 2 ft [61 cm]) with 

the copper tubing. Avoid kinks when coiling the copper 
tubing. 

2. Remove the plastic cap from water valve inlet port. Place a 

compression nut and sleeve on the copper tubing. 

3. Insert the end of the copper tubing into the water valve inlet 

port. Shape tubing slightly so that the tubing feeds straight 
into the port to avoid kinks.

4. Slide the compression nut over the sleeve and screw into the 

water valve inlet port.  

5. Using an adjustable wrench, hold the nut on the plastic water 

line to keep it from moving. Then, with a second wrench turn 
the compression nut on the copper tubing counterclockwise 
to completely tighten. Do not overtighten.

6. Check connection by pulling on copper tubing. Attach the 

plastic water line to the refrigerator cabinet with a “P” clamp.

7. Turn on water supply to the refrigerator and check for leaks. 

Correct any leaks.

1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice. Discard 
the first three batches of ice produced. Allow 3 days to completely 
fill the ice storage bin. 

Refrigerator Door and Drawer

All graphics referenced in the following instructions are included 
later in this section after “Final Steps.”
TOOLS NEEDED: 

⁵⁄₁₆", ³⁄₈", ¹⁄₄" hex-head socket wrench, a ³⁄₃₂" 

hex key, #2 Phillips screwdriver, and a flat-blade screwdriver.

1. Using a

 ³⁄₃₂" hex key, loosen the two setscrews located on the 

side of each handle. See graphics 2 and 4.

2. Pull the handle straight out from the door. Make sure you keep 

the screws for reattaching handles.

3. To replace the handle, reverse the directions.

IMPORTANT: Remove food and any adjustable door bins or utility 
bins from doors.

1. Unplug refrigerator or disconnect power.
2. Keep the refrigerator door closed until you are ready to lift it 

free from the cabinet.
NOTE: Provide additional support for the refrigerator door 
while the hinges are being moved. Do not depend on the door 
gasket magnets to hold the door in place while you are 
working.

B

A

C

D

B

C

D

A