Xerox Xerox Secure Access Unified ID System Support & Software Guía De Instalación
Setting Up the Secure Access Hardware
Xerox Secure Access Installation Guide
29
Manually Assign the IP Address
Follow these instructions only if you are not using a DHCP server to set the IP Address of the
Authentication Device OR if you are using a DHCP server, but prefer to use static IP Addresses rather
than using option 230.
Authentication Device OR if you are using a DHCP server, but prefer to use static IP Addresses rather
than using option 230.
When first powered up, the Authentication Device looks for a DHCP server to secure an IP Address. If
no DHCP server is found, the devices switches to static communication and defaults to a static IP
Address of 192.168.2.1. You can use an Ethernet cable to connect a system (for example, a laptop) to
each Authentication Device, then use a Web Admin tool to change the IP Address, and enter the DCE
Server IP Address.
no DHCP server is found, the devices switches to static communication and defaults to a static IP
Address of 192.168.2.1. You can use an Ethernet cable to connect a system (for example, a laptop) to
each Authentication Device, then use a Web Admin tool to change the IP Address, and enter the DCE
Server IP Address.
Print out the Configuration Tear Sheet found on page 32 before you start. Use this sheet to record the
IP addresses you assign to each Authentication Device.
IP addresses you assign to each Authentication Device.
Configure the Laptop:
The system running the Web Admin tool must recognize the static IP Address before you can access
the Web Admin tool.
1. On the system (laptop) that will run the Web Admin tool, select Network Connections > Local
the Web Admin tool.
1. On the system (laptop) that will run the Web Admin tool, select Network Connections > Local
Area Connection > Properties.
2. Double-click Internet Properties (TCP/IP), then click Advanced.
3. In the IP addresses section, click Add.
4. Enter the following:
3. In the IP addresses section, click Add.
4. Enter the following:
IP Address: 192.168.2.x (where x is an unassigned IP)
Subnet Mask: 255.255.255.0
Subnet Mask: 255.255.255.0
5. Click Add to save the changes.
Use the Web Admin Tool to Set IP Addresses:
Perform the following procedure on each Authentication Device.
1. Use a regular Ethernet cable to connect a laptop to the Downlink port on the Secure Access
1. Use a regular Ethernet cable to connect a laptop to the Downlink port on the Secure Access
Authentication Device.
2. To power up the Authentication Device, attach one end of the AC power cable to the
Authentication Device, then plug the other end into an available outlet.
3. Launch a web browser, and type 192.168.2.1 in the Address field.
This is the factory default IP address assigned to the Secure Access Authentication Device.
Note:
For French, select the link provided.
4. Click on the Configure link at the top of the page.
5. Enter the following to login:
5. Enter the following to login:
User name: deviceadmin
Password: pc_passwd
Password: pc_passwd