Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guía Del Usuario
6. Select either A3 Impression Mode or A4 Impression Mode.
7. Select Save.
8. If necessary, select Close to return to the main Tools screen.
9. Exit the System Administration Mode.
7. Select Save.
8. If necessary, select Close to return to the main Tools screen.
9. Exit the System Administration Mode.
Calibration
Calibrating the Press for Copy and Scan Jobs
When you calibrate, you optimize the quality of copied and scanned jobs. The press
prints a calibration pattern for you to place on the document platen glass. The press
then scans the calibration pattern, and automatically makes adjustments as required.
prints a calibration pattern for you to place on the document platen glass. The press
then scans the calibration pattern, and automatically makes adjustments as required.
Note
This does not improve the image quality of print jobs, only jobs that are being copied
and scanned.
and scanned.
1. Log in as the administrator.
2. Press the Machine Status button on the UI.
3. Select the Tools tab.
4. Select Setup & Calibration > Calibration.
5. Select either Copy Job 1 or Copy Job 2 for the Screen Type.
6. Select Paper Supply and choose the desired paper tray.
2. Press the Machine Status button on the UI.
3. Select the Tools tab.
4. Select Setup & Calibration > Calibration.
5. Select either Copy Job 1 or Copy Job 2 for the Screen Type.
6. Select Paper Supply and choose the desired paper tray.
Note
You should calibrate on your most frequently used paper.
7. Select Start.
By default, the Target is set Copy Jobs Only, so you do not have to change that
setting.
setting.
8. Select Start.
The press prints a calibration chart and instructions display on the UI.
9. Collect the print and follow the directions on the UI to position the target onto the
Document Glass.
a) Place the chart face down with the two square Magenta patches against the left
edge of the Document Glass.
b) Place sheets of white paper over the chart.
10. Lower the Document Feeder Cover and select Start.
The UI displays a Calibration in process message, and then displays a Calibration
has been successfully completed message.
has been successfully completed message.
11. When the calibration is complete, touch Confirm.
12. Select Close.
12. Select Close.
The main Tools tab screen displays.
13. Exit the administrator mode.
Xerox
®
Versant
®
80 Press
5-18
System Administration Guide
Setup and Calibration (Tools Administrator Mode)