Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guía Del Usuario
5. Type the IKE SA Life Time (5-28800 minutes).
6. Type the IPSec SA Life Time (300-172800 minutes).
7. Select the DH Group type.
8. Enable PFS if necessary.
9. Type the Specific Destination IPv4 Address.
6. Type the IPSec SA Life Time (300-172800 minutes).
7. Select the DH Group type.
8. Enable PFS if necessary.
9. Type the Specific Destination IPv4 Address.
10. Type the Specific Destination IPv6 Address.
11. To restrict the press from communicating with devices that are not using IPSec, select
11. To restrict the press from communicating with devices that are not using IPSec, select
Disabled next to Communicate with Non-IP Sec Device.
12. Click Apply to accept the changes or Undo to retain the previous settings.
802.1X Information
802.1X
802.1X is an Institute for Electrical and Electronics Engineers (IEEE) standard that defines
a method for port-based network access control or authentication. In an 802.1X secured
network, the press must be authenticated by a central authority, typically a RADIUS
server, before it can access the physical network.
a method for port-based network access control or authentication. In an 802.1X secured
network, the press must be authenticated by a central authority, typically a RADIUS
server, before it can access the physical network.
You can enable and configure the press to be used in an 802.1X secured network.
Before you begin:
• Ensure your 802.1X authentication server and authentication switch are available
on the network.
• Determine the supported authentication method.
• Create a user name and password on your authentication server.
• Changing and applying 802.1X settings causes the press to restart. Ensure that the
• Create a user name and password on your authentication server.
• Changing and applying 802.1X settings causes the press to restart. Ensure that the
press can be offline for several minutes.
Configuring 802.1X
1. In CentreWare Internet Services, click Properties > Security > IEEE 802.1X.
2. Next to Enable IEE E 802.1x select Enabled.
3. Under Authentication Method, select the method used on your network. Options are:
2. Next to Enable IEE E 802.1x select Enabled.
3. Under Authentication Method, select the method used on your network. Options are:
• EAP-MD5
• EAP-MS-CHAPv2
• PEAP/MS-CHAPv2
• EAP-MS-CHAPv2
• PEAP/MS-CHAPv2
4. Type the Login Name (Device Name) required by your authentication switch and
server.
5. Type the Password, then retype to verify.
6. Select Enabled next to Certificate Validation if necessary.
7. Click Apply to accept the changes or Undo to retain the previous settings.
6. Select Enabled next to Certificate Validation if necessary.
7. Click Apply to accept the changes or Undo to retain the previous settings.
6-37
Xerox
®
Versant
®
80 Press
System Administration Guide
Using CentreWare Internet Services Settings