Craftsman SM1852RC Manual De Usuario

42

43

Periodically, sawdust will accumulate 

under the work table and base. This 

could cause difficulty in the movement 

of the worktable when setting up 

a miter cut. Frequently blow out or 

vacuum up the sawdust.

All the motor bearings in this tool are 

lubricated with a sufficient amount of 

high grade lubricant for the life of the 

unit under normal operating conditions; 

therefore, no further lubrication is 

required.

Lubricate the following as necessary:

Chop pivot: Apply light machine oil to 

points indicated in illustration. 

Central pivot of plastic guard: Use 

light household oil (sewing machine 

oil) on metal-to-metal or metal-to-

plastic guard contact areas as required 

for smooth, quiet operation. Avoid 

excessive oil, to which sawdust will 

cling.

Link: (actuates lower guard movement) 

If down chop motion is hard to start, oil 

link at two screws (1).

Chop pivot

Central pivot of 

plastic guard

1

1