Craftsman 115787 Hoja De Datos Del Producto

Right Release Lever

Left Release Lever

•   Empty the drawer.
•   Fully extend the drawer.

Process:
•  Apply a light film of glass cleaner to the surface where 

the label is to be applied.

•  Peel the label from the backing and place the label in 

position.

•  Check alignment of the label and adjust accordingly.
•  Hold the label in position and squeegee off excess liquid 

with a towel, working from the center toward each end of 
the label.

•  Suggested label location is shown.

•   Push the lever on the right slide down, lift the lever on 
   the left side up. Pull out drawer to remove.

3

slide carrier

slide

Ball bearing slide - Pull slides and slide carrier out to fully 
extended position (see illustration.) Hold the slide on the 
cabinet while aligning it with the slide on drawer. Slightly 
insert one side and repeat for the other side. Slowly push 
drawer to its fully closed position to engage slide. Open 
drawer and reclose to ensure proper operation.

CASTER INSTALLATION (40-INCH CABINET)
Items Needed:
1/4 - 20 x 5/8 Screw (Qty: 16)
1/4-in Nut (Qty: 16) 
7/16-in Wrench
3/8-in Wrench
Process:

• Remove the bottom drawer by following the drawer 
  removal instructions in the operations section.
• Lay the cabinet down on its back. Use packaging 
  material to protect the paint finish.
• Attach the casters using (4) screws and (4) nuts per 

caster. Mount both swivel casters on the same side of 
the unit as the side handle.

• Wrench tighten all screws.
• Return the unit to its upright position.
• Reinstall bottom drawers

1/4-in Nut

1/4-20 x 5/8-in Screw