Craftsman SM2509RC Manual De Usuario

46

47

46

47

Central pivot of plastic guard: Use light 

household oil (sewing machine oil) on 

metal-to-metal or metal-to-plastic guard 

contact areas as required for smooth, 

quiet operation. Avoid excessive oil, to 

which sawdust will cling.

Periodically, sawdust will accumulate 

under the work table and base. This 

could cause difficulty in the movement 

of the worktable when setting up 

a miter cut. Frequently blow out or 

vacuum up the sawdust.

If need to remove small pieces of 

material from the table cavity, see the 

section on Removing and Installing the 

Table Insert on page 21.

To empty the dust bag, remove the 

sawdust bag from the dust port. Open 

the zipper on the sawdust bag and 

empty out the sawdust inside. Close 

the zipper and reinstall the dust bag on 

the dust port as described on page 18.

All the motor bearings in this tool are 

lubricated with a sufficient amount of 

high grade lubricant for the life of the 

unit under normal operating conditions; 

therefore, no further lubrication 

is required.
Lubricate the following as necessary:
Chop pivot: Apply light machine oil to 

points indicated in illustration. 

Central pivot of 

plastic guard (oil here)

Chop Pivot (oil here 

and on opposite side)