Craftsman ZJ4113 Manual De Usuario

FIG. 1

ASSEMBLY

THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH

MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.

FIG. 2

1. Install the column onto the base using the

three column mounting bolts. FIG. 1.

2. If not pre-installed at the factory, install the

table lock handle through the unthreaded hole

on the left of the table support casting. The

handle should engage the thread on the right

side of the table support casting. FIG. 2.

NOTE: When loosening the table lock handle,

be sure to hold the table in place with your

other hand. This will prevent the table from

slipping down the column which may damage

the table or your workpiece.

Tools Required for Assembly

• Adjustable or 13mm Wrench

• Rubber Mallet or Hammer with Block of Wood

Parts Diagram and Parts List

are listed on pages 18 and 19.

Replacement parts can be ordered by calling

1-888-331-4569

www.sears.com

FIG. 3

3. Slide the drill press head onto the column and

center the drill press head over the table and

base. FIG. 3.