Craftsman CLGT2412S-N Manual De Usuario

17 ― English

See Figure 31, page viii
■ Only use a spool with 0.065 inch 

diameter round monofilament line. Use the 

replacement spool specified in the 

NOTE at 

the end of this section.
■ Remove the battery pack.
■ Push in tabs on side of spool cover.
■ Pull spool cover up to remove.
■ Remove the old spool.
■ When installing the new spool, make sure 

the the line is captured in the spool slot, and 

that the end of the line extends approximately 

6 inches beyond the slot.
■ Install the new spool so that the line and 

slot align with the eyelet in the line head. 

Thread the line into and through the eyelet.
■ Pull the line extending from the eyelet so 

that the line releases from the slot in the 

spool.
■ Reinstall the spool cover by depressing 

tabs into slot in the line head and pushing 

down until spool cover clicks into place.

NOTE: Use Craftsman replacement spool 

item number 71.64212

See Figure 32, page viii
■ Remove the battery pack.
■ Push in tabs on side of spool cover and pull 

cover up to remove.
■ Remove the spool from the spool head.
NOTE: Remove any old line remaining on the 

spool.
■ Cut a piece of line approximately 9 ft. long. 

Use only 0.065 in. diameter monofilament 

line. 
■ Insert the line into the anchor hole in the 

upper part of the spool. Wind the line around 

the upper part of the spool clockwise, as 

shown by the arrows on the spool.  

STORAGE
■ Remove the battery pack from the line 

trimmer before storing.
■ Clean all foreign material from the trimmer.
■ Store the product and its accessories in a 

dry, frost free place.
■ Always store the product in a place that is 

inaccessible to children. The ideal storage 

temperature is between 50

o

F and 86 

o

F.

■ Keep tool away from corrosive agents such 

as garden chemicals and de-icing salts.
■ We recommend using the original package 

for storage or covering the product with a 

suitable cloth to protect it against dust.

TRANSPORTATION
■ Switch the product off and remove the 

battery pack before transporting it anywhere.
■ Attach transportation guards, if applicable.
■ Always carry the product by its handles.
■ Protect the product from any heavy impact 

or strong vibrations which may occur during 

transportation in vehicles.

   

Only use the appropriate 

type of cutting line.

Place line in the slot on upper spool flange, 

leaving about 6 in. extended beyond the slot. 

Do not overfill. After winding the line, there 

should be at least 1/4 in. between the wound 

line and the outside edge of the spool.
■ Install the spool in the line head and 

replace the spool cover as described in Spool 

Replacement.