Craftsman 3130eSC Manual De Usuario
Toyota/Lexus OBD1 Systems
ERASING DTCs
112 FixAssist
®
If the Scan Tool cannot link to the
vehicle’s computer after three
attempts, the message “Contact
Technical Support” displays.
vehicle’s computer after three
attempts, the message “Contact
Technical Support” displays.
- Press the SYSTEM MENU
button to return to the Toyota Menu.
-
Turn the ignition off and
disconnect the Scan Tool.
disconnect the Scan Tool.
- Contact Technical Support for
assistance.
5.
If the Scan Tool was able to link to the
vehicle successfully a "Code retrieval
was successful..." message shows
temporarily on the Scan Tool’s LCD
display followed by any retrieved DTCs.
was successful..." message shows
temporarily on the Scan Tool’s LCD
display followed by any retrieved DTCs.
The Scan Tool will display a code
only if codes are present in the
vehicle's computer memory. If no
codes are present, a "No DTC's are
presently stored in the vehicle's
computer" message is displayed.
only if codes are present in the
vehicle's computer memory. If no
codes are present, a "No DTC's are
presently stored in the vehicle's
computer" message is displayed.
6.
If more than one code was retrieved
press the DTC/FF button, as necessary,
to display additional codes one at a time.
to display additional codes one at a time.
In the case of long code definitions, a small arrow is shown in the
upper/lower right-hand corner of the code display area to indicate
the presence of additional information. Use the
upper/lower right-hand corner of the code display area to indicate
the presence of additional information. Use the
and
buttons, as necessary, to view the additional information.
7.
Disconnect the Scan Tool from the vehicle and turn the ignition key OFF.
8.
To prolong battery life, the Scan Tool automatically shuts "Off" after
approximately three minutes with no button activity. The DTCs
retrieved will remain in the Scan Tool's memory, and may be viewed
at any time. If the Scan Tool’s batteries are removed, or if the Scan
Tool is re-linked to a vehicle to retrieve codes, any prior codes in its
memory are automatically cleared.
retrieved will remain in the Scan Tool's memory, and may be viewed
at any time. If the Scan Tool’s batteries are removed, or if the Scan
Tool is re-linked to a vehicle to retrieve codes, any prior codes in its
memory are automatically cleared.
9.
Follow the testing and repair procedures outlined in the vehicle's service
repair manual to correct "hard" DTCs. Codes should be addressed and
eliminated in the order they were received, erasing and retesting after
each repair is made to be sure the fault was eliminated.
eliminated in the order they were received, erasing and retesting after
each repair is made to be sure the fault was eliminated.
ERASING DTCs
When the Scan Tool's ERASE function is used to erase
DTCs from the vehicle's on-board computer, manufacturer
specific data (where applicable) is also erased.
DTCs from the vehicle's on-board computer, manufacturer
specific data (where applicable) is also erased.