Craftsman 11569 Manual De Usuario

9 – English

WARNING: 

Always remove battery pack from your 

tool when you are assembling parts, making adjust-
ments, cleaning, or when not in use. Removing bat-
tery pack will prevent accidental starting that could 
cause serious personal injury.

See Figure 2, page i.
  Lock the switch trigger by placing the rotation selector 

in the center position.

  Depress the latches on the side of battery pack.
  Remove the battery pack from the tool.

 To prevent accidental starting that could 

cause serious personal injury, always remove the bat-
tery pack from the tool when assembling parts.

See Figure 3, page i.
  Remove battery pack.
  Lift blade clamp lock/release lever located on front of 

saw.

  Insert saw blade between blade clamp and saw bar as 

far as possible.

  Release and lock blade clamp lever.
  Replace battery pack.

To obtain the best performance from the saw, it is impor-
tant to select a specific blade for the particular applica-
tion and type of material you wish to cut. By doing this 
you will get a smoother, faster cut and prolong blade life. 
Replacement blades for this saw are available from your 
nearest Sears retail. It is recommended you use a T-shank 
blade. If a T-shank blade is not available, a high quality 
U-shank may be used.

See Figure 4, page i.
A convenient feature on the saw is the blade storage 
compartment. The blade storage compartment is located 
on the back of the saw.  It is convenient for storing extra 
blades and storing blades when not in use.


 

To open: Push the door down with your thumb or 
finger. Place blades in blade storage compartment.



 

To close: Push the door up with your thumb or finger.

See Figure 5, page ii.


  Secure hex key on the saw base behind the rubber 

covered tab. Push into place.



  Make sure the hex key is secured before performing 

any sawing operation.

  Remove by pulling on the hex key.

WARNING: 

Do not allow familiarity with tools to 

make you careless. Remember that a careless 
fraction of a second is sufficient to inflict serious 
injury.

WARNING: 

Always wear eye protection with side 

shields marked to comply with ANSI Z87.1. Failure to 
do so could result in objects being thrown into your 
eyes, resulting in possible serious injury.

WARNING: 

Do not use any attachments or 

accessories not recommended by the manufacturer 
of this product. The use of attachments or 
accessories not recommended can result in serious 
personal injury.

You may use this tool for the following purposes:


  Sawing non-ferrous metal, sheet steel, wood, plastic, 

and similar materials



  Cutting wood surfaces



  Cutting thin sheet metal



  Cutting plastics and laminates

This product will accept Craftsman 19.2 V lithium-ion bat-
tery packs and Craftsman 19.2 V nickel-cadmium battery 
packs. 
For complete charging instructions, refer to the Operator’s 
Manual for your battery pack and charger models.

Craftsman 19.2 V lithium-ion battery packs are designed 
with features that protect the lithium-ion cells and 
maximize battery life. 
If the tool stops during use, release the trigger to reset 
and resume operation. If the tool still does not work, the 
battery needs to be recharged.

See Figure 2, page i.
  Lock the switch trigger by placing the rotation selector 

in the center position.

  Place the battery pack on the tool.
  Make sure the latches on each side of the battery pack 

snap into place and the battery pack is secured on the 
tool before beginning operation.

CAUTION: 

When placing the battery pack in the 

tool, be sure raised rib on battery pack aligns with 
the groove in the tool and that the latches snap into 
place properly. Improper assembly of the battery 
pack can cause damage to internal components.