Craftsman SM2511RC Manual De Usuario
18
19
ASSEMBLY
To avoid injury, do not connect this
miter saw to the power source until
it is completely assembled and
adjusted and you have read and
understood this Operator’s Manual.
ASSEMBLE STAND (FIG. A)
1. Unpack all parts and group by type
and size as shown on page 15.
2. Attach one long upper support
bracket (4) to top of leg (1) using
one carriage
bolt (2) and nut (5).
NOTE:
• Align detents (12) in stand leg
with support brackets to ensure
proper fit.
• Do not fully tighten bolts until
stand is properly aligned (see
step #8).
3. Attach other end of long upper
support bracket to the top of another
leg using one carriage bolt and
one nut.
4. Attach one long bottom support
bracket (3) to the center of each leg
using carriage bolt and nut. This
completes the front frame section.
5. Assemble the rear frame section in
exactly the same manner.
6. Join the front and rear frame
assemblies using two short upper
support brackets (6) and two short
bottom support brackets (8) using
carriage bolts and nuts.
7. Place a foot pad (7) onto each of
the four legs.
8. Place the stand on a level surface
and adjust it so all legs are
contacting the floor and are at
similar angles to the floor and
WARNING
!
detents (12) in stand leg align with
support bracket. Then, tighten all
bolts using a 13mm wrench.
NOTE: Stand should not rock after
all bolts are tightened.
ASSEMBLE MITER SAW TO STAND
(FIG. A)
1. Carefully place the miter saw on top
of stand.
2. Line up the four mounting holes in
the saw base to the stand.
3. Fasten the saw to the stand using
the four mounting bolts (9), four
washers (10) and four nuts (11).
NOTE: Place a washer on each
bolt before inserting it into the saw
base and through the support, then
thread the nut onto the bolt.
(see Fig. A)
4. Tighten all four nuts using a 13mm
wrench.
NOTE: DO NOT OVER TIGHTEN
THE LOCK NUTS HOLDING SAW
TO THE STAND. THIS COULD
DAMAGE THE SAW BASE.
Fig. A
Saw Base (full saw not
shown for clarity of view).
2
8
1
3
4
11
12
6
9
10
5
12
12
7