Craftsman SM2511RC Manual De Usuario
24
25
● Never carry the miter saw by
the power cord or by the trigger
switch handle. Carrying the tool
by the power cord could cause
damage to the insulation or wire
connections and result in electric
shock or fire.
● To avoid injury from flying debris,
do not allow visitors to stand
behind the saw.
● Place the saw on a firm, level
workbench where there is
room for handling and properly
supporting the workpiece.
● Support the saw on a level work
surface.
● Bolt or clamp the saw to its support.
Mounting Instructions:
1.
For stationary use, place the saw
in the desired location, directly on a
workbench where there is room for
handling and proper support of the
workpiece. The base of the saw has
four mounting holes. Bolt the base
of the miter saw (1) to the work
surface (5), using the fastening
method as shown in Fig M.
Fig. M
NOTE: The referenced mounting
hardware is not included with this tool.
Bolts, nuts, washers and screws must
be purchased separately.
2. For portable use, place the
miter saw on a 3/4 in. thick piece
of plywood. Bolt the base of the
miter saw securely to the plywood
using the mounting holes on the
base. Use C-clamps to clamp this
mounting board to a stable work
surface at the worksite. (Fig. N)
Fig. N
NOTE: If a different miter saw stand
is used then the stand provided,
please follow all instructions shown in
that product’s instructions for proper
mounting.
1. Miter saw base
2. Hex head bolt
3. Rubber washer
4. Flat washer
5. Workbench
6. Flat washer
7. Lockwasher
8. Hex nut
9. Jam nut
1
2
3
4
5
6
7 8
9
3/4 in.
plywood