Craftsman SM2511RC Manual De Usuario

8

9

FOR THIS COMPOUND MITER SAW
1. 

DO NOT operate the miter saw 

until it is completely assembled 

and installed according to these 

instructions.

2. 

IF YOU ARE NOT thoroughly 

familiar with the operation of miter 

saws, seek guidance from your 

supervisor, instructor or other 

qualified person.

3. 

ALWAYS hold the work firmly 

against the fence and table. 

DO NOT perform any operation 

free hand (use clamp wherever 

possible).

4. 

KEEP HANDS out of the path of 

the saw blade. If the workpiece 

you are cutting would cause your 

hands to be within 7-1/2 in. of the 

saw blade, the workpiece should 

be clamped in place before making 

the cut.

5. 

BE SURE the blade is sharp, runs 

freely and is free of vibration.

6. 

ALLOW the motor to come up to 

full speed before starting a cut.

7. 

CLEAN and free of chips or dust.

8. 

ALWAYS MAKE SURE all handles 

are tight before cutting, even if the 

table is positioned in one of the 

positive stops.

9. 

BE SURE both the blade and the 

collar are clean and the arbor bolt 

is tightened securely.

10. 

USE only blade collars specified for 

your saw.

11. 

NEVER use blades larger in 

diameter than 10 inches.

12. 

NEVER apply lubricants to the 

blade when it is running.

13. 

ALWAYS check the blade 

for cracks or damage before 

operation. Replace a cracked or 

damaged blade immediately.

14. 

NEVER use blades recommended 

for operation at less than 

 

4800 RPM.

15. 

ALWAYS keep the blade guards in 

place and use at all times.

16. 

NEVER reach around the saw 

blade.

17. 

MAKE SURE the blade is not 

contacting the workpiece before 

the switch is turned ON.

18. 

IMPORTANT: After completing the 

cut, release the trigger and wait for 

the blade to stop before returning 

the saw to the raised position.

19. 

MAKE SURE the blade has come 

to a complete stop before removing 

or securing the workpiece, 

changing the workpiece angle or 

changing the angle of the blade.

20. 

NEVER cut metals or masonry 

products with this tool. This miter 

saw is designed for use on wood 

and wood-like products.

21. 

DO NOT USE this saw to cut tree 

limbs or logs.