Craftsman 115791 Hoja De Datos Del Producto

•   Empty the drawer.
•   Fully extend the drawer.

Slide carrier

Slide

Ball bearing slide - Pull slides and slide carrier out to fully 
extended position (see illustration.) Hold the slide on the 
cabinet while aligning it with the slide on drawer. Slightly 
insert one side and repeat for the other side. Slowly push 
drawer to its fully closed position to engage slide. Open 
drawer and reclose to ensure proper operation.

•   To remove the slide from the unit, first remove the    
   drawer.
•    After removing the drawer check to see if the unit has 

rivets located on the front of the slide. To drill out rivets, 
use a 5/32-in drill bit. The rivets will need to be replaced 
with 5/32-in rivets.

•    To reinstall the slide in the appropriate position in the 

unit, align front and back lances with mounting holes in 
the side of the unit. Pull towards the front of the unit and 
downwards until rivet holes in slide line up with holes in 
the unit. The rivets will need to be replaced with 5/32-in 
rivets.

•   For smooth operation, make sure the drawers are    
   matched with their original slides.

Drill out rivet

•   Push the buttons on the right and left side.
•  Pull out drawer to remove.

•  Locate the drawer lock lever in the center, back of the 

top chest open till area.

•  Move lever to the right to unlock.
•  Move lever to left to lock.

Note: Drawers are only locked when the lever is in the 
“locked” postion. To secure all the content in the top chest, 
lock drawers with the lock lever, close lid and lock lid with 
key.

Button Release

Button Release

A

DETAIL A

Unlocked 

position

3