Honeywell Honeywell Security | Protect What Matters Most Guía Del Usuario
– 20 –
SECURING THE PREMISES
SECURING THE PREMISES
SECURING THE PREMISES
SECURING THE PREMISES
Arming the System
Arming the System
Arming In Away Mode
Use this mode when no one will be staying on the premises. Close all protected perimeter
windows and doors before arming. The green READY indicator on the control should be lit if
the system is ready to be armed. When armed in AWAY mode, the system will sound an
alarm if a protected door or window is opened, or if any movement is detected inside the
premises, when infrared detection devices are used. You may leave through a designated
entrance door during the exit delay period without causing an alarm. You may also re-enter
through the entrance door, but you must disarm the system within the entry delay period or
an alarm will occur. If Quick Arm was programmed by the installer, you do not need to enter
the security code to arm the system. The security code must always be used to disarm the
system, however.
windows and doors before arming. The green READY indicator on the control should be lit if
the system is ready to be armed. When armed in AWAY mode, the system will sound an
alarm if a protected door or window is opened, or if any movement is detected inside the
premises, when infrared detection devices are used. You may leave through a designated
entrance door during the exit delay period without causing an alarm. You may also re-enter
through the entrance door, but you must disarm the system within the entry delay period or
an alarm will occur. If Quick Arm was programmed by the installer, you do not need to enter
the security code to arm the system. The security code must always be used to disarm the
system, however.
The Babysitter Code and Installer Code cannot disarm the system unless it was used to arm
the system. In addition, if the system is armed by pressing via Quick-Arming, neither the
Babysitter Code nor Installer Code can disarm the system.
the system. In addition, if the system is armed by pressing via Quick-Arming, neither the
Babysitter Code nor Installer Code can disarm the system.
Zones
Arm Away
Ready To Arm
Arm Stay
More
Delay
Phone
10:18 AM June 8, 2010
5000-100-006-V0
Message
System
1. Select the Arm Away icon, the system will
beep once and display a keypad.
Ready To Arm
Arm the system in Away mode
Enter Code:
C a n c e l
2
3
1
5
6
4
0
8
9
7
C l e a r
5000-100-053-V0
2.
Enter a valid User Code.
OR
If Quick Arm has been enabled, select the
“
Quick Arm
”
icon.
The system will beep two times and announce
“
Armed Away Exit Now. The exit delay screen
will be displayed. If programmed the display
will count down the time remaining in the exit
delay in seconds.
will count down the time remaining in the exit
delay in seconds.
Note:
If a valid user code is not entered or the Confirm
icon has not been selected within 10 seconds,
the system will return to the
the system will return to the
“
home
”
screen and it
will not be armed.