Zanussi ZCG63330BA Manual De Usuario

• Wire shelf

For cookware, cake tins, roasts.

• Grill- / Roasting pan

To bake and roast or as pan to collect fat.

• Trivet

For roasting and grilling.

Use the trivet only with the Grill- /

roasting pan.

Refer to Safety chapters.

Remove all accessories from the appliance.

Refer to "Care and cleaning"

chapter.

Clean the appliance before first use.

Put the accessories back to their initial position.

You must set the time before you operate the

oven.
When you connect the appliance to the

electrical supply or after a power cut, the

indicator for the Time of Day function flashes.

Press the   or   to set the correct time.

After approximately five seconds, the flashing

stops and the display shows the time of day.
To change the time, press   again and again

until the indicator for the Time of Day function

flashes.

Preheat the empty appliance to burn off the

remaining grease.

Preheat the two ovens. Heat up one

oven at a time.

1. Set the maximum temperature.

2. Let the appliance operate for 1 hour.

Accessories can become hotter than usual. The

appliance can emit an odour and smoke. This is

normal. Make sure that the airflow is sufficient.

Refer to Safety chapters.

Always light the burner before you

put on the cookware.

Be very careful when you use open

fire in the kitchen environment. The

manufacturer declines any

responsibility in case of the flame

misuse.

1. Turn the knob for the hob to the position 

and push it down. When you push the knob,

the spark generator activates automatically.

2. Keep the knob for the hob pushed for equal

or less than 10 seconds to let the

thermocouple warm up. If not, the gas

supply is interrupted.

3. Adjust the flame after it is regular.

Do not keep the knob pushed for

more than 15 seconds. If the burner

does not light after 15 seconds,

release the knob, turn it into the off

position and try to light the burner

again after minimum 1 minute.

If after some tries the burner does

not light, check if the crown and its

cap are in the correct position.

In the absence of electricity you can

ignite the burner without an

electrical device. In this case

approach the burner with a flame,

push the relevant knob down and

turn it to maximum position. Keep

the knob pushed for equal or less

than 10 seconds to let the

thermocouple warm up.