Zanussi ZRB38224XA Manual De Usuario

The compressor operates

continually.

Temperature is set incorrect-

ly.

Refer to "Operation" chapter.

 

Many food products were put

in at the same time.

Wait some hours and then check

the temperature again.

 

The room temperature is too

high.

Refer to climate class chart on

the rating plate.

 

Food products placed in the

appliance were too warm.

Allow food products to cool to

room temperature before storing.

The QuickFreeze function is

switched on.

Refer to "QuickFreeze function".

The compressor does not

start immediately after press-

ing the QuickFreeze, or after

changing the temperature.

This is normal, no error has

occurred.

The compressor starts after a pe-

riod of time.

Water flows inside the refrig-

erator.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that

water flows into the water

collector.

Make sure that food products do

not touch the rear plate.

Water flows on the floor.

The melting water outlet is

not connected to the evapo-

rative tray above the com-

pressor.

Attach the melting water outlet to

the evaporative tray.

Temperature cannot be set.

The QuickFreeze or Quick-

Chill function is switched on.

Switch off QuickFreeze or

QuickChill manually, or wait until

the function resets automatically

to set the temperature. Refer to

"QuickFreeze or QuickChill func-

tion".

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The food products' tempera-

ture is too high.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

Many food products are stor-

ed at the same time.

Store less food products at the

same time.

The QuickFreeze function is

switched on.

Refer to "QuickFreeze function".

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

REPLACING THE LAMP
The appliance is equipped with a longlife LED

interior light.
Only service is allowed to replace the lighting

device. Contact your Authorised Service Centre.