Redmond RJ-907 Manual De Usuario
12
ENGLISH
IV. trouBLE SHootING
V. WArrANty
The period of guarantee for the product is 1 year from the selling date. The guarantee
covers defects of material and workmanship. Under the present guarantee, the manufacturer
undertakes to repair or replace any part recognized as faulty on condition that the product
is sent to the seller. The present guarantee shall be valid only in case the product was used
in compliance with this instruction, no modifications were made to it, it was not repaired or
disassembled by unauthorized persons, or was not damaged due to improper handling. Also,
the complete set of the product must be retained. This guarantee does not cover natural wear of
the product as well as brittle objects such as ceramic components, lamps, etc. The guarantee
shall not become effective unless the date of purchase is confirmed by the seller’s signature and
seal on the guarantee coupon. Any repair under this guarantee shall not extend the period of
guarantee and shall not initiate the beginning of a new guarantee.
In accordance with p.2 of clause 5 of rf federal law «About protection of consumer
rights» the manufacturer assigned the minimum service life for this product, which is
not less than 2 years from the date of manufacture, on condition that it is operated in
strict correspondence with the present manual and stipulated technical requirements.
defect
probable reason
remedy
Juicer is not working
The device is not plugged in
The fixators of the juice are
not closed
Plug the device in.
Turn off the device first!
Turn off the device first!
Close the fixators.
The motor stops during the work
Pulp sticks to the cover
This could be because the
speed is too high or the
pressure on the pusher is
excessive.
Decrease the speed, do not
overload the device with the
produce, use the pusher more
carefully
Pulp sticks to the filter or pulp
comes through with to much
moisture
Filter hasn’t been cleaned after
the last use.
Wash the cellular filter with
warm soap water
Juice comes out of the spout
under high pressure or escapes
from under the cover.
The speed you use is to high
you use excessive force work-
ing with the pusher
Decrease the speed by mov-
ing the switch to “1” position
Reduce the pressure on the
pusher.