Cisco Cisco ASA 5555-X Adaptive Security Appliance - No Payload Encryption Notas de publicación
3
Release Notes for Cisco ASDM Version 5.2(5)
OL-22744-01
Upgrading ASDM
•
ASA 5540
•
ASA 5550
Note
The Cisco PIX security appliance is not supported on ASDM 5.2(5)/ASA 7.2(5).
Upgrading ASDM
This section describes how to upgrade ASDM and ASA to a new ASDM release. If you have a Cisco.com
login, you can obtain ASDM from the following website:
login, you can obtain ASDM from the following website:
http://www.cisco.com/cisco/software/navigator.html
If you have a previous release of ASDM on your adaptive security appliance and want to upgrade to the
latest release, you can do so from within ASDM. We recommend that you upgrade the ASDM image
before the ASA image.
latest release, you can do so from within ASDM. We recommend that you upgrade the ASDM image
before the ASA image.
To upgrade ASDM, perform the following steps:
Step 1
Download the new ASDM image to your PC.
Optionally, you can download a new ASA image to your PC if the installed image is earlier than 8.0.
Step 2
Launch ASDM.
Step 3
From the Tools menu:
a.
In ASDM 5.0 and 5.1, choose Tools > Upload Image from Local PC.
b.
In ASDM 5.2, choose Tools > Upgrade Software.
Step 4
With ASDM selected, click Browse Local to select the new ASDM image.
Step 5
To specify the location in flash memory where you want to install the new image, enter the directory path
in the field or click Browse Flash.
in the field or click Browse Flash.
If your adaptive security appliance does not have enough memory to hold two ASDM images, overwrite
the old image with the new one by specifying the same destination filename. You can rename the image
after it was uploaded using the Tools > File Management tool.
the old image with the new one by specifying the same destination filename. You can rename the image
after it was uploaded using the Tools > File Management tool.
If you have enough memory for both versions, you can specify a different name for the new version. If
you need to revert to the old version, it is still in your flash memory.
you need to revert to the old version, it is still in your flash memory.
Step 6
Click Upload Image.
When ASDM is finished uploading, the following message appears:
“ASDM Image is Uploaded to Flash Successfully.”
Step 7
(For Version 5.x only) If the new ASDM image has a different name than the old image, then you must
configure the adaptive security appliance to load the new image. Use the Configuration > Properties >
Device Administration > Boot System/Configuration pane.
configure the adaptive security appliance to load the new image. Use the Configuration > Properties >
Device Administration > Boot System/Configuration pane.
Step 8
If installing a new ASA image, download the new ASA image using the Tools > Upgrade Software tool
with ASA selected.
with ASA selected.
If your adaptive security appliance does not have enough memory to hold two ASA images, overwrite
the old image with the new one by specifying the same destination filename. You can rename the image
after it was uploaded using the Tools > File Management tool.
the old image with the new one by specifying the same destination filename. You can rename the image
after it was uploaded using the Tools > File Management tool.