Cisco Cisco Email Security Appliance X1050 Guía Del Usuario
3-30
Cisco AsyncOS 8.5.6 for Email User Guide
Chapter 3 Setup and Installation
Using the System Setup Wizard
Private Listener
In this example portion of the
systemsetup
command, a private listener named OutboundMail is
configured to run on the PrivateNet IP interface. Then, it is configured to relay all email for all hosts
within the domain
within the domain
example.com
. (Note the dot at the beginning of the entry:
.example.com
)
The default value for rate limiting (not enabled) and the default host access policy for this listener are
then accepted.
then accepted.
Note that the default values for a private listener differ from the public listener created earlier. For more
information, see
information, see
.
Use the listenerconfig->EDIT command to customize the listener.
*****
Do you want to configure the C60 to relay mail for internal hosts? [Y]> y
Please create a name for this listener (Ex: "OutboundMail"):
[]> OutboundMail
Please choose an IP interface for this Listener.
1. Management (192.168.42.42/24: mail3.example.com)
2. PrivateNet (192.168.1.1/24: mail3.example.com)
3. PublicNet (192.168.2.1/24: mail3.example.com)
[1]> 2
Please specify the systems allowed to relay email through the IronPort C60.
Hostnames such as "example.com" are allowed.
Partial hostnames such as ".example.com" are allowed.
IP addresses, IP address ranges, and partial IP addressed are allowed.
Separate multiple entries with commas.
[]> .example.com
Do you want to enable rate limiting for this listener? (Rate limiting defines the
maximum number of recipients per hour you are willing to receive from a remote domain.)
[N]> n